C.A.R.D. 060 Troubleshooting Guide download pdf (Page 66)

EGPWS LINE MAINTENANCE MANUAL

CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO.: 060-4199-180 REV: G SHEET 66 of 68

16 APPENDIX F: TAKEOFF FLAP CONFIGURATION MONITOR MAINTENANCE

MESSAGES

TABLE F-1: TAKEOFF FLAP CONFIGURATION MONITOR MAINTENANCE MESSAGES

MAINT.

FUNCTION

MESSAGE

Except where noted, all maintenance

message voices are Male

NOTES:

All volume levels at same volume as

existing EGPWS Self-Test messages

Self-Test Level 1

“Flaps Monitor Inhibited”

Takeoff Flap Configuration Monitor enabled, but

the advisories have been inhibited with the

activation of an external input/switch. NOTE –

the EGPWS does not support a dedicated

Takeoff Flap Configuration Monitor inhibit, but

activation of a defined RAAS inhibit will also

inhibit Takeoff Flap Configuration Monitor.

Self-Test Level 1 “Flaps Monitor INOP” Takeoff Flap Configuration Monitor enabled but

the function is inoperative

Self-Test Level 2 “Flaps Monitor Flap Angle Undefined” Takeoff Flap Configuration Monitor function is

enabled but the aircraft does not provide a

source of Flap Position

Self-Test Level 3

(Annunciated at

end of Selected

Options )

“Flaps Monitor Enabled”

RCD Enable Key is set and loaded RCD

activates Takeoff Flap Configuration Monitor

function.

Self-Test Level 3 “RCD Part Number XXX-XXXX-XXX “

where X is the 10-digit installation-specific RCD

part number.

Allows verification that the correct RCD is

loaded into the EGPWS.

NOTE: Operators/Installers must refer to their Instructions for Continued Airworthiness (ICA) documentation to

identify the approved RCD configurations specific to their aircraft type/model having Takeoff Flap

Configuration Monitor installed.

1 2 ... 61 62 63 64 65 66 67 68

No comments

C.A.R.D. 060 Troubleshooting Guide Page 66