C.A.R.D. 060 Installation Manual

® C.A.R.D. MODEL 060 INSTALLATION AND OPERATION MANUAL SURVIVAL SAFETY ENGINEERING INCORPORATED 321 NAVAL

Page# 10 The control panel has a dial that when turned clockwise will activate the system and sets the level of sensi

light from the signal reflected from the coast as well as one from the primary source. Again, by rotating the sensitivity knob a few degrees clockwis

Pin # 1 Red (B= to the antenna ) # 2 Blue Aft Detector # 3 White Stbd Detector # 4 Green Port

Double check that all connections are secure and are set up according to the instructions. Turn the sensitivity control knob clockwise until all

NOTES Page# 14

WARRANTY Survival Safety Engineering, Incorporated Two Year Limited Warranty Every Survival Safety Engineering (SSE) C.A.R.D. Model 060 is thor

You have just purchased one of the most important devices you will ever buy for your vessel. ® C.A.R.D. Model 060, Collision Avoidance

C.A.R.D. SYSTEM COMPONENTS The Antenna with a standard 25 foot cable The Display Unit (Control Module) This Manual INDEX: Warning Page 2

The antenna portion of the unit has four directional receivers that correspond to the four relative display lights on the control unit. A ship op

Unit Installation If you chose to have someone install the C.A.R.D. system for you, ensure that this manual is available to them. It contains

For the antenna cable installation, you have three options : 1) Determine a cable route that does not require deck penetration; or 2) Cut the cab

ANTENNA Page# 7 Stern Rail Mount preferred Antenna Mounts available at most marine stores

CONTROL MODULE WARNING The Display Module IS NOT WATER RESISTANT ! When choosing a location find one that remains dry.

Ma r i n e Radar Detector © Survival Safety E nginee ring, I nc. ON AUDIO HI OFF LOW MODEL 060 8 /7 5Gain Control Audi oHeads-UpDisplayDisplay Bars